Best Wishes Card




Hi everyone, it’s Cheryl with you today.

As you probably already know, I adore the Elegance Collection, and have found it to be very versatile.  Today I have another simple card that I will use as a get well card for a friend who had a fall.

This entire card uses a card base, one 6.5×6.5 sheet of double-sided design paper (CO728830), plus one piece of ephemera and a small amount of white cardstock for the die cutting. I used a scrap for the latter. As you can see, minimal supplies.

Here are the quick and easy instructions. First, I cut the topper to fit my card base, then glued it down. Using the leftover from that piece of design paper, I flipped that over to the reverse side and cut it to fit across the topper as shown.

Next I cut two die cuts using the Beautiful DL Borders die set. I glued one to each edge of the piece that would go across the card, then added the whole thing to the card. Next I added a piece of ephemera, which I put up on foam tape. I then wanted to add my greeting using a small scrap left over from the design paper I’d cut for this card, but it blended into the background too much.

To remedy this, I found a scrap of white cardstock. I cut a small piece of that and added it to the bottom of the greeting. Although small, it was enough to separate the designs.

Last of all, I added some matching adhesive pearls.


This is a very easy card to make, and could be adapted to just about any use.


Complete List of Products Used:


CO728831Couture Creations Elegance Ephemera (set 1)

CO728822Couture Creations 6.5×6.5 Elegance Paper Pad

CO728699 – Couture Creations Smooth White Cardstock – 280gsm

C0725383 – Soft Peach Adhesive Pearls

CO728836 – Couture Creations – Beautiful DL Borders – Elegance Collection

CO728266 – Couture Creations Congratulations Acrylic Sentiment Stamp Set

CO726327 – Couture Creations Tacky Glue 118ml

CO726342 – Couture Creations 12×12 Scoring Board

CO728468 – Trimmer – Guillotine 12inch/30cm

CO721964 – Foam Mounting Tape – 12mm x 4m


Thanks so much for stopping by. I hope you enjoyed my creation.